Òåchnical Specifications
Hydraulic press
| Nominal capacity, tf |
400 |
| Working pressure, kg/cm2 |
200 |
| Plunger stroke, maximum, mm |
200 |
| Belt width, maximum, mm |
1600 |
| Distance between upper and lower heating plates, mm |
200 |
|
Heating plates dimensions, mm
left to right
front to back
thickness
|
1740
1400
70 |
| Steam pressure in heating plates, kg/cm2 |
6 |
| Hydraulic station electric motor power, kW |
9,5 |
Rolling out device
| Belt rolling over rate, m/min |
5...15 |
| Belt width, maximum, ìì |
1600 |
| Belt coil diameter, maximum, ìì |
3000 |
| Height up to axis of fit rod from floor level, mm |
1600 |
| Section of fit rod, mm |
90×90 |
| Supporting roller diameter, mm |
140 |
| Distance between supports, mm |
2000 |
| Drive type |
Reverse,
adjustable
DC |
| Electric motor power, êW |
5,8 |
Controller table
| Guiding rollers diameter, mm |
110 |
| Rollers number |
2 |
Table overalls, mm
left to right
front to back
height from floor level |
1800
1000
850 |
Rolling up device
| Belt rolling over rate, m/min |
5...15 |
| Belt width, maximum, ìì |
1600 |
| Belt coil diameter, maximum, mm |
3000 |
| Height to axis of fit rod from floor level, mm |
1600 |
| Section of fit rod, mm |
90×90 |
| Adjustment of belt width limiters |
By hand |
| Guiding roller diameter, mm |
140 |
| Distance between supports, mm |
2000 |
| Drive type |
Reverse,
adjustable
DC |
| Electric motor power, kW |
5,8 |
Complex overalls, mm
left to right
front to back
height above floor level |
12400
4500
2000 |
|
|
Complex for Roll Over and Repair of Conveyer Belts
Intended for roll over and checking of the belt surface on the controller table. Upon detection of a defective area, the repair of the belt is conducted using the hydraulic press with 400 tf capacity.
Vulcanization (repair) is carried out using heated metal plates with cooling of both ends. In case a defective area was missed, there is an option of returning the belt using reverse drive of the rolling device. The press control system provides an automatic sustaining of the required pressure during vulcanization and preset vulcanization time.
|
